Ford Car Instrument LCD Screen
Home > Touch Panel Digitizer Fitment Guide

Touch Panel Digitizer Fitment Guide

Ford Car Instrument LCD Screen

Touch Panel Digitizer Fitment Guide

Choosing the right replacement glass starts with the unit on your bench, not the badge on the boot lid. This guide sets out the published fitment facts for the TDO-WVGA0633 touch panel digitizer for VW Discover MIB STD2 PQ NAV 5C0035680B units, and it applies the same three checks whether you are quoting a repair job or chasing a Ford car instrument lcd screen for a workshop order: confirm the original part number, measure the panel, and photograph the part before anything is bought. The same discipline holds when a counter request comes in for a Ford instrument cluster display, because a number in a catalogue is only a starting point until the physical part matches.

TDO-WVGA0633Listed SKU on the product page
Touch digitizer onlyPanel supplied without LCD assembly
3–7 business daysTypical dispatch after shipment
TDO-WVGA0633 only Touch Panel Digitizer for VW Discover MIB STD2 PQ NAV 5C0035680B Transporter Amarok Caddy Golf T6 Wifi BT

Published specifications for the TDO-WVGA0633

Every value below is stated on the product listing. Use it as the baseline for your own measurement check, then compare it with the part you are removing.

TDO-WVGA0633 only Touch Panel Digitizer for VW Discover MIB STD2 PQ NAV 5C0035680B Transporter Amarok Caddy Golf T6 Wifi BT
SKUTDO-WVGA0633
Item typeTouch screen / touch panel digitizer only
Panel size6.5 inch
Panel dimensions147.5 × 96 mm
Matched head unitVW Discover MIB STD2 PQ NAV
Matched part reference5C0035680B
Vehicle names on listingTransporter, Amarok, Caddy, Golf T6
Unit price$40.00 (was $85.00)
Wholesale tiers$38.00 for 3–4 pcs · $37.00 for 5–9 pcs · $35.00 for 10+ pcs
Stock status0 in stock — Notify Me and direct contact available

Five checks before you commit to this panel

The listing is precise about what it is: a touch panel digitizer only. Run these checks in order and you will know within a few minutes whether the part on your bench is the one being sold here.

TDO-WVGA0633 touch digitizer panel detail view
Check 01

Measure the glass

Published size is 147.5 × 96 mm on a 6.5 inch panel. Measure your original part across both edges before ordering — a millimetre or two changes the part.

Check 02

Read the part reference

This listing matches reference 5C0035680B. Find the number on your original unit and compare digit for digit; do not accept a similar-looking string.

Check 03

Confirm the head unit

The matched unit is VW Discover MIB STD2 PQ NAV. If your radio carries a different platform label, this digitizer is not the correct replacement.

Check 04

Cross-read the vehicle names

The listing names Transporter, Amarok, Caddy and Golf T6. Treat those names as a prompt to verify your own model, year and original part number rather than as a fitment guarantee.

Check 05

Decide touch fault or display fault

This item is the touch panel only. If the complaint is a blank, lined or dimming display rather than an unresponsive surface, you are looking at a display assembly, not this digitizer.

Check 06

Photograph before you buy

The page invites buyers to send photos of the original part for verification. A front and connector-side photo resolves most fitment doubts before an order is placed.

Match your buying scenario to the right order quantity

Four common buyer situations, each tied to a published fact on the listing and a clear decision on what to order.

TDO-WVGA0633 touch panel digitizer supplied for VW MIB2 navigation units

Repair shop with one unit on the bench

The listing price for a single piece is $40.00. One confirmed vehicle, one measured panel, one order.

Decision: order a single unit once checks 01–03 pass.

Busy workshop restocking

The 3–4 piece band is priced at $38.00 per panel, which lowers the unit cost on a recurring repair line.

Decision: buy the 3–4 pc tier and hold two spares.

Parts distributor building stock

Bands at 5–9 pcs ($37.00) and 10+ pcs ($35.00) reward volume, and wholesale support is offered for distributors.

Decision: request a tiered quotation before committing volume.

Buyer facing a zero-stock listing

The page currently shows 0 in stock alongside Notify Me and direct email contact for wholesalers, repair shops and distributors.

Decision: register for Notify Me and email the part number for a lead time.

Technician diagnosing a display complaint

Where the surface responds but the image fails, the fault sits outside a touch-only part; where the surface is dead, this digitizer is the candidate.

Decision: separate touch faults from display faults before ordering.

Symptom routing: is the digitizer the right part?

Because this listing is the touch panel only, the symptom in front of you decides whether the order is correct. Six common complaints and where each one points.

TDO-WVGA0633 digitizer panel for VW Discover MIB STD2 PQ NAV repairs

Start with the cheapest question

Does the unit still show a clean, complete image? If yes, the display assembly is doing its job and the fault most likely sits in the touch layer this listing supplies. If the image is broken, stop and identify a display assembly instead.

The product page also suggests confirming model, year and original part number, and sending photos of the original part for verification — a practical step before any bench diagnosis turns into an order.

No response to touch

Image intact, taps ignored across the whole screen.

Digitizer candidate

Dead zones at the edges

Part of the surface responds, corners or margins do not.

Digitizer candidate

Cracked or crazed glass

Physical damage to the front surface with the image still good.

Digitizer candidate

Ghost or drifting input

Phantom taps and cursor drift without visible glass damage.

Digitizer candidate

Lines, banding or a blank image

The screen itself fails to render correctly.

Not this part

Dim or dead backlight

Image faint, washed out or absent in daylight.

Not this part

Bulk, wholesale and verification requests

The listing publishes a wholesale ladder and invites wholesalers, repair shops and automotive parts distributors to make contact with part numbers and quantities.

  • Quote with the part reference 5C0035680B and your required quantity.
  • Attach front and connector-side photos of the original part for verification.
  • Ask for current lead time when the listing shows 0 in stock.
  • Order by email at spring@opuradio.com or louis@opuradio.com, or call +8613723403763.
TDO-WVGA0633 touch panel digitizer supplied for wholesale orders

Related Reading

Three notes to help clarify product requirements before contacting the supplier.

What Is a Touch Panel Digitizer on a VW MIB2 Radio?

A touch panel digitizer is the separate touch input layer in a VW MIB2 radio display, while the LCD underneath produces the image.

Read article

Measuring 147.5 x 96 mm Touch Panels for VW MIB2 Fitment

A 6.5-inch label says almost nothing about whether a touch panel will drop into a VW MIB2 bezel, so the 147.5 x 96 mm outline is the number that decides it.

Read article

FPC Cable and Connector Fit on Replacement VW Touch Panels

A replacement VW touch panel can sit perfectly in the bezel and still fail if its FPC tail and connector do not deliver a clean signal.

Read article

Frequently Asked Questions

What information is shown for this product?

review the product details, images, and specifications presented on the official product page.

Where can i check the intended application?

use the application and use-case information published on the official product page.

Which specifications should i confirm before ordering?

confirm the specifications and options listed for the exact product variant before placing an order.

Where can i check available options?

check the official product page or ask the supplier about options shown for the selected product.

How can i request product information?

use the official contact or inquiry path provided on the site.

What should i include in an inquiry?

include the product page, intended use, required quantity, and any specifications you need the supplier to review.

Message Us